Chad_Frazier
Well-known member
Member
- Joined
- Jan 14, 2018
- Messages
- 183
- Points
- 18
This is badass. Great information here brother. I swear no matter how long we are at this I'm always learning something new daily.I make my own BA water
I sterilize vial
Soak rubber stopper in alcohol
Let dry
Rinse vial with ba water last time have a
2 stainless wire, i twist with round punch one side in vise, other with pliers, then while loose wedge punch threw and turn round and round. I make serveral holes per line. inside to hold vials upside down to dry. I connect to a board polyurethaned with long scews to connect wire tight on each side.
Also works for brewing .
I remove vials once dry.
Put in rubber stopper
Then metal crimp top I put over.
I crimp with a butter knife by holding top down I do same with brew
I remove safety top
I fill with 10ml distilled water.
I then get 100 unit 1ml slin pin and draw
Benzoyl Alcohol I fill to the 10mark
I add to distilled water in vial.
In a few minutes a make 20ml ba water
0.10% sterile for injection and use for my hgh, IGF, and peptides.
I refill and reuse same vials serveral times because they remain sterile.
Just a trick that works and saves ordering ba water!!!